M42-HStall torque from 0,76Nm to 0,23Nm
The M42-H motors are electric motors equipped with filter and circuit with one or two Hall sensors. The Hall sensor provides a signal which allows to count the number of rotations of the motor. With two Hall sensors it is also possible to determine the sense of rotation of the electric motor. Thanks to the filter, which is normally made of an LC-circuit, electric motors can be tested in compliance with the EMC directive.
In the technical datasheet it is possible to select the motor shaft, the circuit with one or two Hall sensors and request special cables which have to be indicated in the enquiry form.
In the table named “Electrical Data” it is indicate the voltage range of the M42-H motors’ applications and a list of the performances for the most commonly used voltage values, 12V ad 24V.
The interactive curve allows to select the required performances by selecting power voltage and no-load speed.
The M42-H electric motors are generally applied in linear actuators and in various automatisms.Ask for a quotation
|12 V||24 V|
|Standard nominal voltage||12 V||24 V|
|No load speed
|No load current
|Type of duty||Depending on application|
ShaftSelect the shaft for your motor :
Hall sensor's diagram
Set the characteristic curve
The characteristic curve of the DC electric motors is made of a diagram represented in the Cartesian axis based on the values which are inserted, where once can see represented the torque, in [Nm] (axis X); the rotation speed, in [Rpm] (axis y1); the absorbed current, in [A] (axis y2); the efficiency (axis y3).