GMR59-31-Z4-HStall torque from 17,0Nm to 7,70Nm
The GMR59-31-Z4-H gear motors are equipped with filter and a circuit with one or two Hall sensors. The rotor shaft has a worm with four threads.
The Hall sensor supplies a signal which allows to count the number of rotations made by the motor. With two Hall sensor it is possible to determine also the rotation direction of the electric motor.
The filter, generally made of an LC-circuite, allows the electric motors to be tested in compliance with the EMC norms.
In the technical data-sheet it is possible to select the output gear shaft, the circuit with one or two Hall sensors and to request a particular set of cables by inserting it in the enquiry form.
In the table “Electric Data” one can see the application voltage range and the performances for the most commonly used voltages, 12V and 24V.
The interactive curve allows to select the required performances by selecting the power voltage and the no-load speed.
The GMR59-31-Z4-H electric gear motors are used in linear actuators and in automatisms of various kind.Ask for a quotation
|12 V||24 V|
|Standard nominal voltage||12 V||24 V|
|No load speed
|No load current
|Type of duty||Depending on application|
Hall sensor's diagram
Set the characteristic curve
The characteristic curve of the DC electric motors is made of a diagram represented in the Cartesian axis based on the values which are inserted, where once can see represented the torque, in [Nm] (axis X); the rotation speed, in [Rpm] (axis y1); the absorbed current, in [A] (axis y2); the efficiency (axis y3).